Our CAN/LIN Communication Network Training System primarily uses automobile electronics network such as the CAN bus and LIN bus to implement the data communication of various functional nodes. The PC-end software performs the Baud Rate adjustment of CAN bus and LIN bus, data monitoring and module controls.
Features and Specifications
Our system consists of 3 parts:
Part I: Embedded Hardware (Comprised of the Main Control Board and Module Board)
(1) Main Control Board has built-in multi-voltage supply, and it also provides diverse interfaces such as the USB, ICSP, D-Sub 9-Pin RS232, CAN bus, LIN bus, Mini DIN 6-Pin(for GPS), SPI bus + I2C bus connector (both
parallel-connected for Debugging), 128x64 graphic LCM with touch panel function, and two sets of module connector.(2) Main Control Board contains two E2PROM (16K bit memory) chips, which are interfaced with SPI and I2C respectively. These interfaces are associated with the exterior connector to provide the convenience of data programming as well as debugging.
(3) This system provides 8 different functional and application modules:
7-Seg LED/Buzzer/Temperature Sensor Module
DC Motor Module (incl. 2 motors)
Stepping Motor Module (incl. 2 motors)
Voltage/Current Measurement Module (incl. 2 wire sets)
RFID module (incl. 3 Tags)
Super_201: PIC based CAN application module
GPS CAN application module
GPRS/GSM CAN application module
Part II: Embedded Software
(1) USB Interface Communication Program: Provides the sample code of application program for the communication between PC USB and Main Control Board.
(2) CAN Interface Communication Program: provides the sample code of application program for CAN communication between PC USB and Main Control Board.
(3) RS232 Interface Communication Program: Provides the sample code of application program for on board RS-232 communication.
(4) LIN Interface Communication Program: Provides the sample code of application program for LIN Master/Slave communication between PC USB and Main Control Board.
(5) Module Board Control Programs: Provides the Sample Code for module controls.
Part III: PC-end Software
(1) USB function: Plug & Play PC-end driver can communicate with Main Board.
(2) CAN function: Set CAN Baud Rate, Message Viewer and Message Sender (Send/Receive from CAN nodes of Main Control Board)
(3) LIN function: Set LIN Baud Rate, Message Viewer (Receive from LIN node of Main Control Board).
(4) Module Board function: Monitor and control the function of each module board.
(5) Diverse CAN Adapters can be applied to the Main Control Board to Send/Receive messages.